PETG-CF filaments for 3D printing
PETG reinforced with carbon fibres. High strength and rigidity, minimal warping, technical matte surface. For functional parts, brackets, drones and components under mechanical stress.
Buying guide
PETG-CF filament is PETG reinforced with short carbon fibers. It retains the toughness and chemical resistance of standard PETG, but it is significantly stiffer, warps and shrinks less, and has a subtly matte surface. It is therefore suitable for technical and functional parts that must not bend and need to maintain precise dimensions. In our selection, you will find Prof. lab brand PETG-CF in a 1.75 mm diameter on a 1 kg spool, available in several colors.
Practical uses for PETG-CF
Carbon fibers give parts stiffness and dimensional stability, while PETG provides resistance to impacts, moisture, and common chemicals. The matte surface also hides individual layer lines well.
- Mounts, brackets, and clamping jigs for the workshop that must not yield under load.
- Electronics enclosures and cases where precise dimensions matter.
- Parts for drones and RC models where you need stiffness at a low weight.
- Functional prototypes, tools, and technical parts with a professional matte look.
Recommended print settings for PETG-CF
The following values are based on the manufacturer's technical data sheet and the data for our products. The values listed directly on the spool always take precedence. Carbon fibers are abrasive, so using a wear-resistant nozzle is necessary.
| Parameter | Value |
|---|---|
| Nozzle temperature | 240 to 270 °C |
| Bed temperature | 80 to 90 °C |
| Print speed | 30 to 60 mm/s |
| Cooling | 30 to 50% |
| Enclosed chamber | Recommended, especially for larger parts |
| Nozzle type | Hardened steel or another wear-resistant nozzle |
| Drying | 65 to 75 °C for 4 to 6 hours |
PETG-CF, standard PETG, or PLA-CF?
Standard PETG is cheaper, prints at lower temperatures, and works fine with a standard brass nozzle. If the part does not need to be exceptionally stiff, it is a reasonable choice. Choose PETG-CF when the part bends under load or when you need more precise dimensions and a matte technical surface. Compared to PLA-CF, PETG-CF can withstand higher temperatures and is tougher, so it performs better outdoors or in warmer environments, for example. PLA-CF, on the other hand, prints more easily, at lower temperatures, and without the need for a heated chamber.
Frequently asked questions about PETG-CF
Do I need a special nozzle for PETG-CF?
Yes. The carbon fibers will quickly wear out a standard brass nozzle, causing the orifice to enlarge and print quality to drop. For PETG-CF, use a nozzle made of hardened steel or another wear-resistant nozzle.
Do I need to dry PETG-CF before printing?
PETG-CF absorbs moisture from the air. If bubbles appear on the surface, if the print is rough, or if you experience poor layer adhesion, dry the spool in a filament dryer at 65 to 75 °C for 4 to 6 hours. Store unused material in a sealed bag with desiccant.
What build plate should I print PETG-CF on?
It adheres well to PEI, textured PEI, and glass at a bed temperature of 80 to 90 °C. The manufacturer recommends a thin layer of glue or 3D printing spray, which improves adhesion.
Explore all filaments in our selection as well. For parts without extreme stiffness requirements, standard PETG filaments are suitable. For easy printing of stiff parts without a heated chamber, choose PLA-CF filaments, and for a clean look without shine, check out matte PETG.